• Basic Root 66: with 1/2 hp Motor with Rev. Switch, 10-ft Power Cord with GFI, Leather Gloves (cables and cutter heads sold separately)
• Three-in-one machine
• Clears 1-1/4” through 4” drain lines
• Can drive 5/8” cables for lines up to 3” and 7/8 cables for 4” lines (sold separately)
• Change cables instantly–no tools or adapters required
• Wide four-point base for greater stability
• Heavy-duty sealed 1/2 hp motor
• Bearings are protected from dirt and moisture by two gaskets
• Ground fault circuit interrupter for electrical safety
• Oversize keyed jaws for longer life and less slippage. The same jaws drive both 5/8" and 7/8" cables

The Root 66 is a real advance in sectional cable machine design. No mid-range machine has its versatility and power.
Look at its versatility. You can drive 5/8″ cables for lines up to 3″ and 7/8″ cables for 4″ lines – and you can switch from one to the other in seconds, without touching the jaws, without an adapter, without tools. And for sink drain work, slip on a drum that holds smaller cables.
To operate, just feed a cable into the line and slide the back end into the machine. The excess cable goes into a guide tube. Turn on the sealed motor, press down on the handle, and the Root 66 starts spinning the cable at 400 rpm.
The cable stops rotating as soon as you lift the handle, so there’s no additional torque buildup. When using a drum for small drain work, the drum stops turning when you lift the handle to the neutral position.