• Compatible with Tripp Lite B160-Series A/V over IP receivers
• Video source can be sent to any analog or digital display
• Supports video resolutions up to 1920 x 1440, including 1080p*
• HDMI output on transmitter for connecting local display
• Plug and play—no software or drivers required *Limited to maximum resolution of receiver

Converts VGA video + audio to an IP-based signal that is transmitted point-to-point to a receiver 328 ft. away via Cat5e/6 cable or through a dedicated Ethernet network switch.
Distributes VGA A/V, Serial and IR Control Signals over Cat5/6 Cabling
■ Converts audio/video to an IP-based signal that is transmitted point-to-point to a display 328 ft. away
■ Add low-cost network switches between transmitter and receiver to continue extending distance up to 328 ft. per switch
■ HDMI output for connecting a local display Create a Multi-In, Multi-Out Installation Using B160-Series Transmitters and Receivers
■ Connect up to 64 transmitters and 255 receivers through multiple dedicated managed network switches
■ IGMP-enabled switches allow centralized control over which sources show on which displays
■ Video source can be sent to any analog or digital display, so you can mix and match technologies and use existing monitors Enhanced Technical Features
■ Supports video resolutions up to 1920 x 1440, including 1080p (limited to receiver’s max resolution)
■ Uses H.264 video compression standard
■ Transmits on 20–60 kHz IR frequency
■ Extends IR control signals that control a source from a remote display
■ Supports RS-232 serial baud rates up to 57600 Bps
■ HDCP and 3D compatible Plug-and-Play Functionality
■ No software or drivers required
■ Hardware included for mounting on wall, rack or pole
■ Compatible with all Tripp Lite B160-Series A/V over IP receivers TAA-Compliant
■ Compliant with the Federal Trade Agreements Act (TAA) for GSA Schedule purchases