SAP2-kit Probe kit

Features

• For SAP2500D probe

The SAP2500D Differential probes are provided with numerous features and accessories to make probing and connecting to different test points easier than ever. Descriptions of each accessory item are as follows:

Straight Tip - The straight tip is rugged and designed for general probing. Fits in either probe socket.

Pogo Tip - The pogo tip provides z axis compliance. The tip can fit into a socket or via and onto an IC leg.

Swivel Tip - The swivel tip adapter features adjustable tip spacing to reach test points. A 20 Ω damping resistor is included to reduce inductive peaking.

Tip Saver - To prevent wear out on the probe input leads.

Y Lead Adapter - This lead is used for both ground and input lead simultaneously. It has two sockets on one end and two square pins on the other and may be used for general purpose probing.

Straight Pin Leads - These leads have a socket on one end and a square pin on the other to connect to the input or ground socket of the probe body, and may be used for general purpose probing.

Right Angle Pin Leads - These leads have a socket on one end with a right angle and a square pin on the other to connect to the input or ground socket of the probe body, and may be used for general purpose probing.

Spring-loaded Ground - Spring-loaded ground leads are bendable. They are designed to be attached to the offset ground socket or be attached to either socket of the probe head.

Solder-in Lead - This lead is designed to be soldered directly to the test points for a secure connection. A damping 56.2 Ω resistor is included to reduce inductive peaking.

Channel ID Clips - They are used to distinguish the oscilloscope channel that the probe is connected to.

What's in the Box

• 5x Straight Tip (Part 2.74.70.12.003)
• 5x Pogo Tip (Part 2.74.70.12.004)
• 2x Swivel Tip (Part 2.74.70.10.018)
• 2x Tip Saver (Part 2.74.70.10.019)
• 2x Y Lead Adapter (Part 2.52.42.11.026)
• 1x Right Angle Pin Lead (Part 2.52.42.11.016)
• 1x Straight Pin Lead 6 cm (Part 2.52.42.11.017)
• 1x Straight Pin Lead 12 cm (Part 2.52.42.11.019)
• 2x Spring loaded Ground (Short) (Part 2.52.42.11.025)
• 2x Spring loaded Ground (Long) (Part 2.52.42.11.028)
• 2x Solder in Lead (Part 2.52.42.11.027)
• Channel ID Clips (set of 4) (Part 2.75.23.10.003)