Techni-Tool
HumiSeal
HumiSeal

HumiSeal 1B31 Acrylic Conformal Coating, Clear, 1 Gallon

Our Part #127-467

Condition:New

Mfr Part #1B31

HumiSeal
HumiSeal

HumiSeal 1B31 Acrylic Conformal Coating, Clear, 1 Gallon

Our Part #127-467

Condition:New

Mfr Part #1B31

Hazardous
Cannot Ship Air
CA Prop 65
$469.78EACH
Hazardous
Cannot Ship Air
Calif. Prop 65
  • HumiSeal 1B31 Acrylic Conformal Coating is a one component, fast curing acrylic coating that is used for circuit assemblies and can be easily repaired. It offers excellent flexibility, moisture and environmental protection, and fluoresces under UV light to aid inspection. It can be applied by spraying, brushing, or dipping methods. 1 Gallon

A conformal coating for printed circuit assemblies, fluoresces under UV light for ease of inspection. The final film demonstrates excellent flexibility and is easily repairable.
Cleanliness of the substrate is of extreme importance for the successful application of a conformal coating. Surfaces must be free of moisture, dirt, wax, grease, flux residues and all other contaminants. Contamination under the coating could cause problems that may lead to assembly failures.

Dipping Depending on the complexity, density and configuration of components on the assembly, it may be necessary to reduce the viscosity of HumiSeal 1B31 with HumiSeal Thinner 503 in order to obtain a uniform film. Once optimum viscosity is determined, a controlled rate of immersion and withdrawal (5-15 cm/min) will further ensure even deposition of the coating and ultimately a uniform film. During the application, evaporation of solvent causes an increase in viscosity that should be adjusted by adding small amounts of HumiSeal Thinner 503. Viscosity in the dip tank should be checked regularly using a simple measuring device such as a Zahn or Ford viscosity cup.

Spraying HumiSeal 1B31 can be sprayed using conventional spraying equipment. Spraying should be done in an environment with adequate ventilation so that the vapour and mist are carried away from the operator. The addition of HumiSeal Thinner 521 is necessary to ensure a uniform spray pattern resulting in pinhole-free film. The amount of thinner and spray pressure will depend on the specific type of spray equipment used and operator technique. The recommended ratio of HumiSeal 1B31 to HumiSeal Thinner 521 is 1:1 by volume, however the ratio may need to be adjusted to obtain a uniform coating.

Brushing HumiSeal 1B31 may be brushed with a small addition of HumiSeal Thinner 503. Uniformity of the film depends on component density and operator's technique.

BrandHumiSeal
ColorClear
MaterialAcrylic
Temperature Range-65 to 125°C
Container Volume1 gal.
FlammableYes
Cure Time24h @ room temperature; 30min @ 76 C
Flash Point-1 C
Specific Gravity0.88
Tack Life10 min.
$469.78EACH