American Beauty - Purging Your Solder Pot - A Step-By-Step Guide
Our thanks to American Beauty for allowing us to reprint the following article.

There may be times when it will become necessary to remove the existing solder alloy from your solder pot crucible. When this situation arises it is very important for you to remember that you will be handling a very hot molten solder material and you should exercise extreme caution throughout the entire purging process.
Caution: Never attempt this process without using protective shielding devices and heat resistant attire.


You will need to have a discard receptacle for collecting the solder that is being removed from your solder pot. This can be a reservoir made from aluminum foil that is nested inside a larger container on a blanket of noncombustible material such as sand, vermiculite or clay based kitty litter. Make sure that the receptacle is of a sufficient size to accept all of the solder that is being removed from the solder pot.


The work area, solder pot and discard receptacle that are being used for this process should all have highly visible signs and posted markings warning personnel of the intense heat and the potential for severe burns that may exist. The work surface that you intend to use for this procedure should be smooth, level, and heat resistant. It is also a good idea to have the work surface covered with a protective sheet of noncombustible material in case there are any accidental spills or splashing of the hot molten solder...


Read More



*Download Article in PDF Format Click to download article in PDF format